- +31 344 577 884
- This email address is being protected from spambots. You need JavaScript enabled to view it.
- Mo - Fr 09:00 - 17:00
Support
- What can I use Altair Inspire for?
- What is Topology Optimization?
- What is the technology behind it?
- Does Inspire calculate frequency modes?
- What is that brown optimized shape, is it geometry?
- What does Safety Factor mean in Inspire?
- Why is there a slider that can move or subtract material after the optimization, while the result should be optimal anyway?
- Can Altair Inspire handle non-linear behaviour?
- Can I optimize for a situation where two forces would act against each other, shifted in time?
- If I run my simulation, why is the result failing for Safety Factor while there is still plenty of material to add by using the slider in the results dialog?
- The optimization is running for a long time without a warning, how can I check the status?
- Does Inspire run on a Mac?